Quote from Colin on 31st December 2010, 10:23 am

Hi all

I've now recieved all the other payments from-

Rsmul
KenA
&
Sam

So will be paying in the cheques today and ordering the goods on Tuesday.

Quote from Colin on 18th January 2011, 12:57 pm

Hi to all...Quick update

I haven't left the country just got caught up with lots of stuff. Just to let you know the distributors are ordered and should be here in the next few days plus I have ordered up, and recieved the wire etc. for the bypass loom-all I need to do now is dig the soldering iron out and make them (and some fitting instructions) up.

I'll let you know when but i am hoping to despatch them later this month.

Quote from Colin on 31st January 2011, 11:46 am

Just to let you know the dizzys are here and I have made up/attached the bypass looms for the ballast resistors. The only thing I have left to do is to make up the wiring instructions which I'll work on this week.

Quote from Nellie on 10th February 2011, 5:42 pm

Hi Colin,

Any idea when they'll be getting posted out?

Cheers

Col

Quote from Colin on 10th February 2011, 6:53 pm

Hi Col

Sorry...Life is too hectic already this year and the sun hasn't started shining yet.

Got slightly delayed with producing the fitting instructions, which are now all done but having checked the dizzies over I have found that they have not been sent with the correct uprated rotor arm-which is on the way. As soon as it turns up and they are fitted I'll get them packed and off to the 'Posty'. It will be next week but not sure which day I'll be around to get into town with them-will advise when sent though.

Quote from Raz on 13th August 2012, 9:38 am

Hi Colin

Just wondered if you had made any spare bypass looms for ballast resistors? I am thinking it is about time l went down the electronic ignition route, but it seems somewhat complicated by the ballast resistor built into the standard set up.

Look forward to hearing from you.

Ray

Quote from Colin on 20th August 2012, 6:49 pm

Hi Ray

No but I have all the bits to make one up only problem is time as mad at the moment due to work, wedding & honeymoon...if you can wait til the end of sept then no problem 😉

Quote from Raz on 21st August 2012, 10:08 am

Hi Colin

No problem whatsoever. Sounds like you have more than enough to occupy your time and thoughts at the moment!

Best of luck with it all.

Ray